Quarter Wave Box Calculator 21

ewpoikart.netlify.com › █ █ Quarter Wave Box Calculator 21

Quarter Wave Box Calculator 21 Rating: 3,0/5 5138 votes

Jun 06, 2010 Quarter Wave / T-Line tutorial-UPDATED Sign in to. Heres the formula, its simple, you would just need a pen, paper, and calculator. Quarter wave is all based on speed of sound, and length of the sound wave. And the sub will sound like its being pushed to hard-boost for tline have to be close to the quarter wave of the box as possible. This calculator can be used to design a Quarter Wave Ground Plane antenna, with. Of household mains copper wire and a scrap BNC socket from the junk box.

Overview: This is a calculator for designing a 1/4 Wave Flared Vent T-Line/Horn/Bass Reflex Enclosure. The formulas used in the calculator create a design that suggests the most maximally flat response in an anechoic environment based on the number of drivers, the thiele small parameters and the allotted dimensions specified in the user’s input fields. The calculator does NOT take into account the effects of placing the enclosure into the listening environment. This type of enclosure may not be the most suitable option for your application.

I recommend reading the articles in the category on box design for further information. Feel free to check out the other calculators on the site as they may provide the results you are looking for. —> You can also request a totally custom design for your driver(s)/application by filling out the form in the page. The spreadsheet calculator loads via iframe below the diagrams.

You can also access the spreadsheet. Instructions: This calculator requires the input of your driver’s thiele small parameters.

This design is a “driver specific” enclosure design and it is crucial to have the correct thiele small parameters for your driver(s) in order to achieve the intended alignment model from the formulas. • Begin by filling in the input fields (white boxes) for your “Driver Specifications” in the spreadsheet. • Scroll down to the “Maximum Dimensions” section and fill in the field labeled “Material Thickness” with the width of the material you plan to use to build your enclosure out of.

• Fill in the fields for the “External Height” and “External Width.” The calculator will automatically calculate the “External Depth” so take measurements of your allotted space and make sure it will all fit! • Under the “Enclosure Specifications” section, fill in in the field labeled “Chamber Depth.” This is where your driver(s) will be situated so it is advisable to compensate for its mounting depth. 3 for a clear visual as to what this dimension is. • Now for a little trial an error!

Under the “Enclosure Specifications” section, you will notice the fields labeled, “1/4 Wave Tuning Point,” “Port Frequency 1,” “Port Frequency 2,” and “Box Frequency.” In order to achieve the intended alignment model of the formulas in the calculator, you must try and get these numbers as close to the same as each other. So if the “1/4 Wave Tuning Point” is 41.5 hertz, try to get the “Port Frequency 1,” “Port Frequency 2,” and “Box Frequency” as close to 41.5 hertz too. Plus or minus 1-2 hertz is acceptable. • Use the “Port Front Width,” “Port Rear Width,” and “Port Exit Width” fields to fine tune the frequencies towards a closer match. Just keep into consideration to stay within the minimum or maximum x-sectional area recommendations for each field.

• After you have finalized your design, refer to the “Panel Dimensions” section for a complete listing of panels you will need for your build. (Panel’s dimensions are in inches.) Hint: Some of the fields in the spreadsheet may appear mislabeled. Simply click on the field and view the input bar at the top of the spreadsheet for the correct text. This page is subject to revisions.